Analysis · Water quality

Analysis of water quality in reprocessing

Chemical and microbiological water analyses to assess water quality within medical reprocessing processes – as a basis for reliable cleaning, disinfection and sterilisation.

  • SN EN ISO 15883
  • SN EN 285
  • MedDO (SR 812.213)
  • GPA

Purpose

Water quality affects the result of every process step

Water is used in almost every reprocessing step – from cleaning and final rinsing to steam generation. Unsuitable water quality can cause residues, discolouration and corrosion on medical devices and impair the process result.

With our water analyses, you can assess whether the water used meets the requirements of your processes and devices and identify the need for action at an early stage.

Typical sampling points

  • Supply and water treatment, e.g. softened or fully demineralised water
  • Final rinse water in WDs and EWDs
  • Feed water for steam generators and steam sterilisers
  • Other sampling points by arrangement

Scope of service

Chemical and microbiological assessment

We tailor the range of parameters to your processes, devices and sampling points.

01

Chemical analysis

Depending on the application, for example conductivity, hardness, pH value and substances that can lead to residues or corrosion.

02

Microbiological analysis

Assessment of the microbiological quality, in particular of the water that comes into contact with the reprocessed medical devices during the final rinse.

03

Assessment

Comparison of the results with the requirements of your processes and devices and derivation of measures.

What you receive

Complete, traceable documentation – as the basis for your release, internal audits and official inspections.

  • Agreed plan with sampling points and parameters
  • Documented sampling
  • Analysis results per sampling point
  • Assessment against the applicable requirements
  • Recommendations in case of deviations

Standards & basis

Standards-compliant and in line with Swiss requirements

We follow the applicable standards, guidelines and regulatory requirements – and document what each assessment is based on.

SN EN ISO 15883Requirements for WDs – including the quality of the water used
SN EN 285Large steam sterilisers – requirements for the quality of feed water and condensate
MedDO (SR 812.213)Swiss Medical Devices Ordinance – requirements for maintenance and reprocessing of medical devices
GPA«Good Practice for the Reprocessing of Medical Devices» – Swiss guideline for reprocessing

Procedure

How we proceed

  1. Enquiry & clarification

    We clarify your water supply, devices and question.

  2. Planning

    Sampling points, parameters and date are defined and agreed with you.

  3. On-site execution

    The samples are taken professionally at the defined sampling points.

  4. Evaluation & assessment

    The results are compared with the requirements and professionally assessed.

  5. Report & recommendations

    You receive the report with assessment and recommendations for the next steps.

Frequently asked questions

Good to know

Why is water quality important for reprocessing?

Substances in the water can cause residues, discolouration or corrosion, and unsuitable microbiological quality can contaminate reprocessed medical devices again.

Which parameters are examined?

That depends on the sampling point and application. We agree the scope with you in advance.

How often should water quality be tested?

The interval is set by the operator – for example as part of validation and requalification or after changes to water treatment. We support you in defining it.

Request a quote

Non-binding quote for your facility

Briefly tell us the device type, number and make. We will get back to you personally and prepare a quote that suits your equipment.

  • Personal response from our specialists
  • Manufacturer-independent for all makes
  • Active throughout Switzerland
By submitting, you agree to the processing of your details in accordance with our privacy policy.